Dirty Anchor™ - Pro Ceramic Kit

Dirty Anchor™ - Pro Ceramic Kit brings the best professional level ceramic coating solution directly to the boat owner or professional installer.  This kit offers unparalleled protection by applying Dirty Anchor™ - Protect which is specifically formulated for fiberglass and gelcoat surfaces that are in a harsh water environment.  The second layer is a graphene coating specifically formulated for marine vessels.  The combination of these two coating will protect your boat for years to come.   Think of it, for a fraction of the price of a professional application, you can have unmatched shine and protection, not to mention, not needing to touch your boat with a buffer for 6+ years.

Make sure to review the boat size chart to ensure you have the correct amount of product to coat your entire boat!

Dirty Anchor™ - Protect is a clear, nano-crystalline ceramic coating that protect fiberglass and gelcoat substrates from weather, chemicals, physical abrasion and UV rays while repelling water, dirt and other contaminants via a self-cleaning effect. Dirty Anchor™ Finish will apply an ultra-hard, inert, durable surface that is several microns thick and imparts a deep, reflective shine.

Dirty Anchor™ Finish is a graphene-oxide modified ceramic coating that protects substrates from weathering, chemicals, physical abrasion and UV rays while repelling water, dirt, and pther contaminants via a strong self-cleaning effect. Dirty Anchor™ Finish imparts an ultra-hard, inert, durable film that is several microns thick and produces a deep, reflective, mirror-like shine and highly slick surface

Included in the kit:

1 - 16oz bottle of Dirty Anchor™ - Prep

1 - 2oz bottle of Dirty Anchor™ - Protect

1 - 2oz bottle of Dirty Anchor™ - Finish

4 - Suede Applicators

8 - Microfiber buffing towels

4 - Pairs of Rubber Gloves

1 - Pelican Style Waterproof Case

Directions: 

*Please use the protective gloves provided in your kit in all of the following steps.

 Dirty Anchor™ Prep:

1 – Spray Prep, both on your clean microfiber towel that is included in the kit and on the desired surfaces you are preparing.

2 – With a wiping motion, clean the surface in preparation of the application of The Dirty Anchor™ - Pro Ceramic system as described below.

3 – It is recommended that you test this in a small inconspicuous area first, ** ensure this product performs as desired.

Dirty Anchor™ - Protect:

1 - Once the surface is clean, saturate a suede applicator that is included in the kit with numerous drops of material from the dripper bottle. 

2 - Apply the coating to a 3 ft x 3 ft area of the vessel using a cross-hatch pattern with slight overlap to level the product. 

3 - Wait until it becomes tacky and then gently remove excess material using a clean microfiber towel included in the kit. Check with your finger to assess tackiness. 

4 - Do NOT allow coating to come in contact with water for 24 - 48 hours while curing - if it does, remove water promptly. 

5 - Additional coats are not needed, but if desired, allow at least one hour between applications. 

6 - Do NOT apply in direct sunlight or to a hot surface. Cure time is dependent on environmental conditions.

7 - Test product on a small inconspicuous area first to gauge cure time.

Dirty Anchor™ - Finish:

1 – After waiting 24 ** 48 hours, follow the steps 1 through 7 above for Dirty Anchor™ - Protect.  You can repeat these steps for each additional layer.

 Make sure to check out our Dirty Anchor™ Ceramic products such ** Dirty Anchor™ - Glass, Vinyl, Canvas and Boost kits to protect every part of your vessel.