Dirty Anchor® Boost - Use Instructions

Dirty Anchor® Boost is designed either enhance and support your ceramic coating or to be applied by itself to promote surface protection and a hydrophobic surface.

Preparation: 

1. Thoroughly clean the surfaces with either Dirty Anchor® Prep  or a ph balanced boat soap and water that 
2. You are going to apply Dirty Anchor® Boost.  
3. Let surface dry
4. Remove storage cap from your bottle of Dirty Anchor® Boost and insert the sprayer.
5. Twist nozzle tip clockwise at least 1 full turn. Turn nozzle to adjust spray pattern as desired.
6. Shake well.

Use Instructions:

1. Spray Dirty Anchor® Boost directly onto a clean microfiber towel to moisten the surface
2. spray Dirty Anchor® Boost directly onto the surface you are protecting
3. Using the wet microfiber towel, spread the Dirty Anchor® Boost evenly over the surface.
4. Using a dry microfiber towel, wipe the surface until it is dry.
5. Continue until all of the desired surfaces have been protected.