Dirty Anchor™ - Boost Kit

While Protect, Finish, and Guard provide unparalleled protection and a very slick surface, Dirty Anchor™ - Boost Kit was developed to further reduce friction and provide an active wear layer on top of Guard, Protect, and Finish.  Yearly application of the Boost Kit will keep your boat clean and add additional protection to prolong the life of your ceramic base coatings. 

Included in the kit:

1 - 16oz bottle of Dirty Anchor™ - Prep

1 - 16oz bottle of Dirty Anchor™ - Boost

4 - Microfiber buffing towels

4 - Pairs of Rubber Gloves

Directions:

*Please use the protective gloves provided in your kit in all of the following steps.

Dirty Anchor™ Prep:

1 – Spray Prep, both on your clean microfiber towel and on the surface of your vessel.

2 – With a wiping motion, clean the surface in preparation of the application of Dirty Anchor™ - Boost as described below.

3 – It is recommended that you test this in a small inconspicuous area first, to ensure this product performs as desired.

Dirty Anchor™– Boost:

1 - Thoroughly spray Boost onto entire work surface.

2 - With a clean rag, spread Boost across the entire surface. Do not apply pressure, simply spread Boost so that it is evenly distributed on the surface. 

3 - Allow Boost to partially dry for 1 minute, then wipe up the excess. You can apply multiple coats if desired. Reapply Boost as needed.